Subscribe
Subscribe
Utah FORGE logo - Updated 2025



Scientific Research
Community Outreach
Explore
Subscribe

Seismic Monitoring Well 56-32

This well is the fourth and deepest of a cluster of vertical seismic monitoring wells that are located near the toe of 16A(78)-32. The well was drilled vertically to a total depth of approximately 9,000 feet about 1300 feet north of 58-32.

Well 56-32 will be fully cased (5 ½ inch) and used for deployment of seismic sensors during stimulation experiments. A Silixa DAS fiber optic cable 7500 feet long will be cemented along the outside the casing. During the drilling of 56-32, MSE (Mechanical Specific Energy) calculations and PDC bits will be used to optimize penetration rates as was successfully utilized in the drilling of 16A(78)-32. Below 7500 feet depth, mud hammer bits will be trialed and evaluated for drilling performance.

Update February 8:

Well spudded at 4am.

Update February 9:

Drilled to 380 ft depth.

Update February 10:

Drilled to 3,300 ft depth. The basement contact was crossed at 3,100 ft.

Update February 17:

Drilled to 5,840 ft depth.

Update February 21:

Well reached TD of 9,145 ft depth.

Worth noting: 

This well, as well as the deep, highly deviated 16A(78)-32, was drilled with specially modified polycrystalline diamond composite or PDC bits. These bits proved superior to the tricone bits used in drilling the previous wells.

According to Reed Hycalog, the bit manufacturer, drilling well 56-32 set a record for a bit run of 1208 ft in 53 hours, drilling on average 25 ft/hr in hot, crystalline granite.

Latest Posts

View More
Drilling first deep well announcement

Drilling first deep well announcement

Oct 30, 2020

Utah FORGE Drills First of Two Deep Wells The Utah Frontier Observatory for Research in Geothermal Energy (FORGE), is excited to announce that the drilling of its first highly deviated deep well has commenced. Highly deviated wells are frequently drilled for oil and...

read more
Modeling and Simulation Forum #2 RECORDING

Modeling and Simulation Forum #2 RECORDING

May 26, 2020

Utah FORGE Modeling and Simulation Forum #2 "Hydraulic Fracture Stimulation Patterns in the FORGE Reservoir Using Multiple Stochastic DFN Realizations and Variable Stress Conditions" presented by Aleta Finnila (Golder) May 20 at 11 am MDT The presentation includes a...

read more

Utah FORGE

Advancing innovative technologies to unlock Earth’s limitless geothermal energy.